Is it okay to go through the wood near foundation to get to the main?Īlso do I need to use any type of sealant On top of meter box where the ridged meets the flange?Īny Info on the service mast / conduit to main box will be a big help as i cant find any info on this. What do I use for conduit from Meter box To main? (schedule 80?) ( Is there something better to use) From weather head down to top of meter understand. So now I Have it all planed out I'm ready to get started BUT I have an issue. It has gained around 10000 installs so far, with an average rating of 4.0 out of 5 in the play store. Obviously I should not trust the wiring in the house (all 7 receptacle it has) so I plan to run new circuits with a new main all to code, using running board, GFCI Sockets, dedicated circuits, 20 amp for bathroom, blah. MEATER is an Android Food & Drink app developed by Apption Labs and published on the Google play store. Then I fastened all romex in basement to floor joist. These feeder wires are known as the line wires, and the line side of the meter box is the upper section. The fuse box and Breaker box are rusted missing covers and about to fall of wall.įirst thing is first I supported pipes with real pipe supports then unwrapped romex from pipe. The Romex that was not drooping WAS SUPPORTING PIPES! I had romex just strung across the basement not fastened just drooping. Now the meter box and main panel are back to back on same wall. This will ensure that breaker screws will tighten down on bare wire. of insulation from the ends of hot wires before inserting them into breaker lugs. Note this a fuse box that is piggy backed to a breaker box (AT lugs). A sweeping bend looks best, so try to maintain that angle for all hot wires as you attach them to breakers on both sides of the panel. The service cable goes in to the box NOT CLAMPED. The service cable leaves the meter box running down wood siding ( not fastened) in to a hole that was drilled In the wood right before The Block foundation, In to the basement. The service cable is ran down wood siding NOT FASTENED TO THE HOUSE OR SIDING then in to the meter box. There is a over head service drop to my houseįrom where The weather head should be to the main panel / disconnect the service cable is not In any type of conduit. New here but after reading a few sections of the national electrical code and flipping through lots of books and looking online I need info on conduit.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |